2-10. Jack Board - Sony SRS-ZR7 Service Manual

SRS-ZR7
Ver. 1.2

2-10. JACK BOARD

Note 1: When replacing the JACK board, refer to refer to "Note 3"
(US and CND models only) on page 24.
filament tape
(sub material)
1 filament tape
(sub material)
4 connector
(CN905)
5 flexible flat cable
foot cushion
–
18
CN906
JACK board
CN902
CN905
This side is the terminal side.
3 connector
(CN902)
2 connector
front side
(4 pin) (CN906)
guideline
7 HIMELON 30
JACK board
6 screw
(BVTT3
–
9 foot cushion
bracket (PWB MAIN)
Insert the connector straight into the interior.
There is a possibility that using this unit without
the connector correctly installed will damage it.
Insert straight into
the interior.
connector
connector
When installing the flexible flat cable, ensure that
the colored line is parallel to the connector after insertion.
Insert straight into the interior.
flexible flat
cable
(CN903)
colored line
connector
top side
sheet (USB static) or
EMC sheet
guideline
(edge of the connector)
USB connector
8 sheet (USB static)
Note 2: For US and CND models, part has been changed to
the Sheet (USB static) from the EMC sheet, from
the midway of production.
5)
6 screw
(BVTT3
0 JACK board
NG
Insert only part way. Insert at a slant.
connector
connector
connector connector
NG
Insert at a slant.
flexible flat
cable
colored line
connector
13 mm guideline
HIMELON 30
–
5)
NG
–