Cord Storage - Kenwood CAP70 Instructions Manual

Key
Can piercing lever
1
Cutter
2
Magnetic lid holder
3
Drive wheel
4
Bottle opener storage
5
Removable bottle opener
6
Knife sharpener
7

Cord storage

8
To Use Your Can
(A—E)
Opener
1 Plug the can opener into the
power supply.
2 Lift up the piercing lever.
3 Place rim of the can firmly
under the magnetic lid holder
and against the drive wheel.
4 Press the lever lightly down.
The self starting blade will
operate and pierce the can
and start cutting.. (It is not
necessary to hold the piercing
lever down during the cutting
action).
Note: It is recommended to
l
hold the bottom of large, heavy
or wide cans during the cutting
action.
This can opener will easily open
l
all standard-size cans.
5 Once the top of the can is
opened the motor will stop
automatically.
6 After cutting hold the can and
lift the lever up. The lid will be
retained by the magnet.
Using the Bottle
(G)
Opener
1 Remove the bottle opener from
the storage compartment.
2 Place the bottle opener on top
of the bottle cap with the metal
blade under the rim of the cap.
3 Lift up the end of the bottle
opener to remove the bottle
cap.
English
Using the Knife
Sharpener
1 Place the cutting edge of the
knife in the slot located on the
back of the can opener.
2 Draw the knife blade through
the slot several times.
NOTE: This sharpener will not
l
sharpen serrated knives.
Take care not to allow the
l
knife to cut into the body of
the can opener.
Cord Storage
Use the compartment at the back
to store the cord when not in use.
Care and Cleaning
(F)
1 Unplug the appliance from the
power supply before cleaning.
2 Lift the lever and remove.
3 Wash the lever in hot soapy
water and dry thoroughly.
Dishwashing is not advised.
4 Replace the lever.
5 Wipe over the body with a
damp cloth and dry thoroughly.
4
(H)
8