Advertisement
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of your can opener.
Important – UK only
The wires in the cord are coloured
as follows:
Blue = Neutral, Brown = Live.
The appliance must be protected by
a 3A approved (BS1362) fuse.
Note:
For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
This appliance conforms to EC
Regulation 1935/2004 on materials
and articles intended to come into
contact with food.
Your Kenwood Can Opener can be
used to open a variety of domestic can
shapes and sizes. In addition the
CO600 incorporates a bottle opener
and a knife sharpening facility.
key
bottle opener
drive wheel
magnet
lever
cutter blade
guide pin
knife sharpener
cord stowage
using your table top can
opener
1 Plug the appliance into the power
supply.
2 Lift the lever to the open position.
3 Hold the can with the top rim resting
under the metal guide pin and the
can resting on the drive wheel
4 Press the lever lightly down to start
the motor. The self-starting blade will
then pierce the can and commence
cutting
.
5 The can will be held fixed in position
with the magnet resting against the
lid. Large or wide cans may require
extra support from the user.
6 Once the can is open, the motor will
automatically stop, retaining the can
and lid safely in place.
7 To remove, lift the lever whilst
holding the can.
8 With the exception of aluminium
cans, the lid will be retained by the
magnet
.
9 For tidiness, any unwanted length of
cord can be stowed inside the
appliance.
10 Do not use the appliance to open
ring-pull cans.
using the bottle opener
When opening tall bottles, the unit
should be used towards the edge of
a work top.
1 Position the bottle with the cap
under the front rim of the bottle
opener
.
2 Push down the bottle to remove the
cap whilst steadying the unit with
one hand.
using the knife
sharpener
1 With the can opener sideways on,
place the knife into one of the
recesses.
2 Gradually draw it towards yourself.
Then place the knife in the other
recess and repeat. Take care not to
allow the knife to cut into the body
of the can opener.
3
.
Advertisement
