Panasonic BL-C111A Integration Notes page 11

H L C
OME OGIC ONFIGURATION
The following table provides settings used in the HomeLogic Configurator. Please refer to the Configurator Reference Guide for more details.
In the table below:
"<User Defined>", etc.
o
O H S V 4.0
NE OME OFTWARE ERSION
Devices Variable Name
Communication Device N/A (See Note 1)
Video Cameras Name
Device Type
Location
IP Address
Port
UserName
Password
Low-Res Panning
Flip Image 180
Hide Resolution Control
Hide Full Screen Control
Default Resolution
Goto Preset when Idle
Record Resolution
Record Tolerance
Motion Detect
Software Motion Trigger
Notes:
1. No Communication Device is needed: just add Video Cameras.
2. By default, set the first camera to 192.168.0.80, the second to 192.168.0.81, and so on.
D
ETAILS
Type in the desired name for the item.
Setting
N/A (See Note 1)
<User Defined>
Panasonic BL-C111A
<User Defined> (Not Required)
<User Defined> (Default: 192.168.0.80) (See Note 2)
80
<User Defined> (Default: Administrator)
<User Defined> (Default: password)
<Select> (Default: <No>)
<Select> (Default: <No>)
<Select> (Default: <No>)
<Select> (Default: <No>)
<Select> (Default: <Auto>)
<Select> (Default: <NONE>)
<Select> (Default: <Don't Change>)
<Select> (Default: 0% (Keep All Frames))
<Select> (Default: Disabled)
<Select> (Default: 50%)
Comments
Typically left at 80
Set to YES if camera is inverted
Camera will Pan/Tilt/Zoom as applicable to a certain preset when no streams active.
Don't Change will default to last active resolution, or set a specific resolution for recording
Higher will discard frames with no motion to conserve disk space
Enable to trigger event maps when motion detected (DVR)
Lower is more sensitive.
11 of 11