King Quest VQ4100 Quick Reference Manual page 2

3
Set up TV and receiver.
4
Make connections.
5
After making connections, wait 10 seconds for the system to boot up.
Press and release the power inserter button.
The antenna will start scanning for the DIRECTV 101 satellite.
!
DO NOT MOVE THE ANTENNA UNIT WHILE IT IS SCANNING.
When the satellite is found, your programming will appear. Enjoy!
The antenna begins scanning when you press and release the button. PLEASE BE PATIENT! The antenna may lock on
the satellite in as little as 2 minutes, but may occasionally take up to 10-15 minutes.
If you wish to start a new scan (for example, the unit gets moved and you lose reception): press and release the power
inserter button. This is the only way to start a new scan.
The KING Quest is not programmed to lock on the 119 satellite, so you will not receive your local channels if they are
broadcast from the 119.
Access the full KING Quest manual at kingconnect.com/support. We're here to help! Call 952-345-8147.
Place the power inserter in an accessible location.
Do not overtighten the coax connections.
!
Do not put sharp bends or kinks in the coax cable.
Do not route the coax cable where it can be tripped on or run over by a vehicle.
All trademarks are the sole property of their respective owners.
For a list of compatible receivers, go
to kingconnect.com/support and click
on Receiver Compatibility.
All components sold separately.
21962 Rev E © 2019 KING