RESETTING THE TV TO FACTORY
CONDITION
Use the following instructions to restore the User Adjustments and
Channel Memory settings to the preset factory conditions.
1. Turn the TV On by pressing
2. While holding down the
press the POWER button on the side of the TV.
3. The set restarts and displays the Initial Setup screen.
This may take several minutes.
KDL-32EX427/32EX527/40EX527/46EX527
SECTION 7 - SERVICE ADJUSTMENTS
POWER
.
on the Remote Commander,
RESETTING THE TV TO FACTORY CONDITION
USING SERVICE MODE
1. TV must be in standby Mode. (POWER off).
2. Press the following buttons on the Remote Commander
within a second of each other:
DISPLAY
Channel 5
If necessary, press JUMP or OPTIONS to go to DIGITAL
mode.
3. Press the following buttons on the Remote Commander
within a second of each other:
Press 8
MUTING
"SERVICE" changes to green RST.
RST executes the command and displays EXE.
EXE-RST displays green, then red indicating the TV is
writing the data.
4. When the process is complete the green SERVICE text
displays and the LED display as shown below:
TIMER
TIMER
5. Cycle AC Power
(Unplug and Plug AC Cord from the AC Outlet).
The set restarts and displays the Initial Setup screen.
This may take several minutes.
Volume +
POWER
0 .
Standby
Standby
POWER
POWER
70