Ibeacon Broadcast Information; Configuration; Data Indication - Ebyte E104-BT06 User Manual

Ble4.2 smd bluetooth-serial port module

Table of Contents

Chengdu Ebyte Electronic Technology Co., Ltd.

0x03

Note: This data does not require user configuration.

iBeacon broadcast information

Instructions to configure UUID, Major, and Minor respectively



Command AT+ADV=2 to configure to work in iBeacon broadcast mode, broadcast immediately



Bluetooth connection is not supported in iBeacon broadcast mode



Advertising

iBeacon Prefix

E.g：0201061AFF4C000215FDAFDA50693A4E24FB1AFCFC6EB076478252775848F00

The module supports two configuration methods: serial port configuration, air configuration (FFF3 characteristic

value). The two configuration methods are basically the same. Before the air configuration, the authentication

password of AT+AUTH=123456 must be passed. After the authentication is passed, the module is allowed to use

the air configuration. The air configuration authentication cycle is this connection, and re-authentication is required

if the device is disconnected and reconnected.

When the module outputs data through the serial port, the module sets the DATA pin to a high level, indicating that

data is being sent. AT command response does not change the DATA pin state.

FFF0

e.g：0303FFF0<len>09< Device name >

UUID

Major

16B

0x09

Configurable, maximum 22 bytes

Minor

E104-BT06 User Manual

Tx-Power

Table of Contents