Advertisement
Assembly - Attaching the Lights
2
Installing the bulbs and shatter
resistant bowl
WARNING: Allow the shatter resistant bowl to cool completely
before removing.
CAUTION: Make sure the power is off before attaching or
removing the shatter resistant bowl.
CAUTION: Do not over tighten the hex nut, overtightening the
hex nut may cause the shatter resistant bowl to break.
□
Remove the finial and the bottom cover from the threaded
nipple of the light kit fitter assembly (E).
□
With the power off, install the two LED bulbs (I) by screwing
them into the light bulb sockets.
□
Position the shatter resistant bowl (H), re-install the bottom
cover over the threaded nipple, and direct the fan pull chain
through the side hole of the bottom cover.
□
Re-install the finial over the threaded nipple and direct the
light pull chain through the hole of the finial, and tighten the
finial securely.
□
Attach the pull chain extensions (GG) provided to the light
pull chain and fan pull chain.
Assembly - Assembling the Fan Without the Light Kit
1
Assembling the fan without the
light kit
□
In order to use the fan without the light kit, remove the
switch cup cover (WW) from the top of the light kit fitter
assembly (E) by removing the center hex nut inside the
switch cup cover (WW), and then thread the switch cup
cover (WW) off of the threaded nipple on the top of the
light kit fitter assembly (E).
□
Press the plastic plug (FF) into the center hole of the
switch cup cover (WW).
□
Remove the three screws (V V) on the switch cup cover
(WW).
□
Align the three holes in the switch cup cover (WW)
with the three holes in the switch cup of the fan-motor
assembly (D). Make sure the notch in the switch cup
cover (WW) clears the reversing switch in the switch cup
of the fan-motor assembly (D).
□
Re-install the three screws (V V) that were removed in
first step to secure the switch cup cover (WW).
D
E
H
GG
V V
13
Please contact 1-855-HD-HAMPTON for further assistance.
I
D
GG
WW
FF
HAMPTONBAY.COM
Hide quick links:
Advertisement
