Connect The Cable To The Outdoor Unit - Panasonic CU-4E23QBR Service Manual

10.5 Connect the Cable to the Outdoor Unit

1. Remove the control board cover metal from
the unit by loosening two screws.
2. Cable connection to the power supply through
isolating Devices (Disconnecting means).
Connect approved type polychloroprene
o
sheathed power supply cord
3 x 2.5 mm
designation or heavier cord to the
terminal board, and connect the others
end of the cord to Isolating Devices
(Disconnecting means).
3. Connecting cable between indoor unit and
outdoor unit shall be approved
polychloroprene sheathed 4 x 1.5 mm
cord, type designation 60245 IEC 57 or
heavier cord.
5. For wire stripping and connection requirement, refer to the diagram below.
6. Secure the power supply cord and connecting cables onto the control board with the holder.
7. Attach the control board cover back to the original position with screw.
2
60245 IEC 57 type
2
4. Connect the power supply cord and
flexible
44
connecting cable between indoor unit and
outdoor unit according to the diagram as
shown.