Udp Server Instructions - Ebyte E810-DTU User Manual

Chengdu Ebyte Electronic Technology Co,.Ltd
E810-DTU User Manual
Figure 18 Data transparent transmission

6.2.3 UDP Server instructions

(1) Connect two E810-DTU(RS232)-V2.0 serial ports and network cables to PC, open the network configuration
software and search for the device. The searched device will display the device list. Double-click the device to be
configured in the list and enter the setting interface. Set the module to UDP Server mode, set the target IP address to
192.168.3.100, set the target port of module A to 8887, the target port of module B to 8886, set the RF parameters, click
the OK button after the setting is complete, and then restart the device to search Check once to see if the parameter
modification was successful.
27
Copyright ©2012–2020, Chengdu Ebyte Electronic Technology Co,.Ltd