Reset Button - LEGRAND XFS-1816P Quick Install Manual

Indicator
POWER
SYSTEM
PoE Max
Link/Act
PoE
Note: At startup, port LEDs will flash as a self test.

Reset Button

The Reset button (located at the lower-right corner of the front panel) is used to reset (or reboot) the switch, or to
restore the switch factory default settings.
To Reset the Switch:
With the XMS-1816P powered on, press and hold the Reset button approximately eight seconds, until both the
Link/Act and PoE LEDs turn off, then release the Reset button and the switch automatically restores factory default
settings and reboots. Once the System LED starts flashing again, the XMS-1816P is running with factory defaults.
CAUTION: Do not hold the button for more than a second. Doing so could erase all settings and
restore factory defaults.
Safety instructions
This product should be installed in compliance with installation rules, preferably by a qualified electrician. Incorrect installation and
use can lead to risk of electric shock or fire.
Before carrying out the installation, read the instructions and take account of the product's specific mounting location.
Do not open up, dismantle, alter or modify the device except where specifically required to do so by the instructions. All Legrand
products must be opened and repaired exclusively by personnel trained and approved by Legrand. Any unauthorised opening or
repair completely cancels all liabilities and the rights to replacement and guarantees.
Use only Legrand brand accessories.
State
On
XFS-1816P is switched off or not connected to AC
Off power. Check power connections and power switch
On
Flashing
The XFS-1816P is in startup and initialization process
Off
Connected PoE devices are exceeding the rated PoE
On
Off
On
Flashing
Off
A PoE-enabled device is connected and the switch is
On
No PoE-enabled device is connected or PoE is not
Off
8
Description
The XFS-1816P is switched on.
at the back of the unit.
The XFS-1816P is booting.
The XFS-1816P is running normally.
or is not on.
power output of the switch.
PoE power functioning within limits.
There is a device connected to the port.
Port is receiving or transmitting data.
No device is connected to the port.
supplying power to the device.
enabled on this port.