Getting Connected; Hardware Operation; Status Indicators - LEGRAND XFS-1816P Quick Install Manual

3 - Preparing for Access
IP Addressing
If the XFS-1816P is connected to a network with a 192.168.0.X address scheme, and your computer shares a similar
address on the same network, you can skip to the next step, "Access and Setup".
CAUTION: If another device on your network shares the 192.168.0.4 address, you'll need to temporar-
ily reassign or remove that device while you configure the XFS-1816P.
If your network uses an address scheme other than 192.168.0.X, you'll need to set a temporary static IP address
on the computer you're using for configuration. To do so, set the IP address of your computer to an address in the
192.168.0.X range, then set the Gateway/Router address to 192.168.0.4 (the default IP address of the XFS-1816P).
Once you're finished configuring the switch, you can return your computer's IP configuration to normal, typically
"Obtain Automatically/DHCP".
NOTE: For more information, please refer to the "help configuring Access" (E-Catalogue Legrand).
4 - Access and Setup

Getting Connected

Use an Ethernet cord to connect your computer to the XFS-1816P, then power on the switch.
Logging In
To access the XFS-1816P web configuration, open your web browser and enter the switch's default 192.168.0.4 IP
address in the address field. Log in to the switch using the default user name and password:
Select the menu items on the left to view and/or modify the configuration.
CAUTION: This product must be set up by an confirmed network administrator.

5 - Hardware Operation

The front panel of the XFS-1816P switch includes sixteen 10/100/1000 Mbps RJ 45 PoE+ ports, two Gigabit Uplink
ports, and one SFP port shared with Uplink port 1. The front panel also features a set of LED status indicators.

Status Indicators

Each of the 16 PoE+ ports has a corresponding LED for Link/Act and PoE. There are also two uplink LEDs, one Power
LED, one System LED, a PoE Max LED and a reset button to reboot the device or restore factory default settings. The
following table describes the LED functionality:
Default IP: 192.168.0.4
Username: admin
Password: admin
XFS-1816P Front Panel
7