LEGRAND XMS-1208P Quick Install Manual page 8

Mode/Reset Button to Change LED Functionality
Tapping the Mode/Reset button briefly switches the port indicators between displaying port link speed and PoE
status. The following chart shows the LED indicators of the XMS-1208P along with an explanation of the indicator's
properties:
Indicator name
System
Port Link/Act
Status 1-12
Port PoE
Status 1-8
Note: At startup, the port LEDs will flash briefly during a self-test.
Mode/Reset Button to Reset/Restore
The Reset button (located at the center of the front panel) is used to reset (reboot) the switch, or to restore the switch
to factory default settings.
To Reboot/Reset the switch:
With the XMS-1208P powered on, press the Reset button for approximately three seconds until the Link/Act and PoE
LEDs both light, then release the button.
CAUTION: Do not hold the button for more than four seconds. Doing so could erase all settings and
restore factory defaults.
To Restore Default Setting
With the XMS-1208P powered on, press and hold the Reset button approximately eight seconds, until both the
Link/Act and PoE LEDs turn off, then release the Reset button and the switch automatically restores factory default
settings and reboots. Once the System LED starts flashing again, the XMS-1208P is running with factory defaults.
CAUTION: Please note that restoring Default Settings will remove any/all custom configuration.
Safety instructions
This product should be installed in compliance with installation rules, preferably by a qualified electrician. Incorrect installation and
use can lead to risk of electric shock or fire.
Before carrying out the installation, read the instructions and take account of the product's specific mounting location.
Do not open up, dismantle, alter or modify the device except where specifically required to do so by the instructions. All Legrand
products must be opened and repaired exclusively by personnel trained and approved by Legrand. Any unauthorised opening or
repair completely cancels all liabilities and the rights to replacement and guarantees.
Use only Legrand brand accessories.
State
Flashing
On
Indicates startup/initialization process or that power
Off
Green
Yellow
Flashing
Off
Green
PoE is off due to a fault or because the connected
Yellow
Off
8
Description
Indicates normal operation.
Indicates a malfunction.
Contact support.
is not on.
1000Mbps device connected to the port.
10/100Mbps device connected to the port.
Port receiving or transmitting data.
Nothing connected to the port.
Switch is providing PoE power to a device.
device is exceeding power limit.
Port disconnected or link failed.