MANN LAKE MD-175 Quick Manual

MANN LAKE MD-175 Quick Manual

10 lb wax melter

Advertisement

1. Attach control to the port
on the side of the melter.
10 lb Wax Melter

Attaching Control and Power Cable

2. Attach power cable to the control
port. Connection is magentic.
NOTE: Do not submerge melter
in water. Remove control and
power cable when cleaning. Do
not clean the interal parts of the
control or power plug.
DO NOT exceed warm setting on
control. Heating wax beyond this
setting will cause discoloration.
The flashpoint of beeswax is 400°
F (204.4° C). DO NOT HEAT WAX
TO 400° F (204.4° C).
501 1st St S, Hackensack, MN 56452
500 Santa Anita Dr., Woodland, CA 95776
485 Stewart Rd, Wilkes-Barre, PA 18706
1600 Commerce Street, Marshall, TX 75672
Telephone: 800-880-7694
www.mannlakeltd.com
MD-175
March 20, 2018 3:12 PM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MD-175 and is the answer not in the manual?

Questions and answers

Summary of Contents for MANN LAKE MD-175

  • Page 1 10 lb Wax Melter MD-175 Attaching Control and Power Cable NOTE: Do not submerge melter in water. Remove control and power cable when cleaning. Do not clean the interal parts of the control or power plug. DO NOT exceed warm setting on control.
  • Page 2 Melting Wax • Set dial to warm; do not use higher settings. • Place desired amount of wax in the melting pot, not exceeding the wall height of the pot • Allow wax to melt slowly; do not leave the Wax Melter unattended during operation. •...

Table of Contents