Advertisement
Quick Links
Assembling Your Langstroth Hive Body & Super
What you will need for Assembly:
• 2 Ends
• 2 Sides
• Hammer
• Nails (sold separately)
• Construction Square
→
Slide fingers together
Step One:
Take 1 side and 1 end and put the
fingers together. Make sure your
hand holds are facing up and facing
out.
Hand holds facing
up and out
→
Place nails into pre-drill area on
fingers and hammer in.
Step Two:
Put a construction square onto each inside
corner of the box. Put nails into the pre-drilled
area on fingers before nailing the final side/
end. A box that is not square will not sit proper-
ly on the hive. Once square, pound in your nail.
501 1st St S, Hackensack, MN 56452
500 Santa Anita Dr., Woodland, CA 95776
485 Stewart Rd, Wilkes-Barre, PA 18706
1600 Commerce Street, Marshall, TX 75672
Telephone: 800-880-7694
www.mannlakeltd.com
Rev: 1/14/16 MLL 01-INS
Advertisement
Related Manuals for MANN LAKE Langstroth
Summary of Contents for MANN LAKE Langstroth
- Page 1 Assembling Your Langstroth Hive Body & Super What you will need for Assembly: • 2 Ends • 2 Sides • Hammer • Nails (sold separately) • Construction Square Hand holds facing up and out → Slide fingers together → Place nails into pre-drill area on fingers and hammer in.
- Page 2 *Once assembled you should treat the Step Three: outside with a primer and paint. Repeat steps one and two. You May Also Consider..Metal Frame Rest: Used to protect the wood from damage caused by scraping and hive tool wear. Specialty Nails: These cement and resin coated specialty nails are specifically designed with a small...
Need help?
Do you have a question about the Langstroth and is the answer not in the manual?
Questions and answers