Draytek VigorAP 802 Quick Start Manual page 6

Installation
This section will guide you to install the AP and make configuration for VigorAP.
3.1 Connected As a Mesh Node (in Mesh Network)

Plug VigorAP into a power outlet.

As a mesh node, settings related to VigorAP 802 must be configured by a
remote Mesh Root (e.g., VigorAP 903) within the mesh network. The user
must detect VigorAP 802 via a Mesh Root to add it as a mesh node.
3.2 Connected As an Access Point
As an access point, VigorAP 802 must be connected to a router and configured in AP
(Access Point) / Range Extender mode.

Plug VigorAP into a power outlet.

Use a twisted-pair cable with RJ-45 plugs at both ends, and plug into
Ethernet device (e.g., Vigor router) and Ethernet port of VigorAP.