Kohler Clearflo K-7160 Installation Instructions page 4

Assemble the handle to the overflow hood with the screw
provided. It may be necessary to adjust the handle to the
desired position.
Insert the drain stopper into the drain ell.
The drain stopper should rise approximately 3/8" (1cm)
above the strainer. To adjust the stopper height, remove
the stopper and loosen the nut below the stopper. Raise
the stopper by turning counterclockwise, or lower by
turning clockwise.
If sufficient clearance cannot be obtained by adjusting the
stopper, remove the lift rod assembly. Loosen the screw,
and slide the adjusting block up on the adjusting rail to
increase the clearance, or down to decrease the
clearance. Tighten the screw, and insert the lift rod
assembly back into the overflow ell.
BC
113176-2-
Fig. #10
Fig. #11
Toggle
Fig. #12
Adjusting Block
Adjusting Rail
Fig. #13
4
Handle
Overflow
Hood
Stopper
Nut
Lift Rod
Assembly
Screw
Kohler Co., Kohler, WI U.S.A.