Advertisement
1. Lash only to objects with rounded edges. Avoid sharp corners.
WARNING! Lashing to objects with
sharp edges can cause line to chafe
and break suddenly when load is
applied.
2. Always lash to mouth of the block. Head is not strong enough to secure line.
WARNING! Lashing to head of block seriously weakens the block. This will cause the
block to break suddenly when load is applied. Always lash to mouth.
3. Use three laps of line to create six strands to match the maximum working load of the block.
WARNING! Using fewer laps will weaken block causing it to break suddenly when
load is applied. Use three laps of line.
Three laps, six strands are
required for proper strength.
Planning Installation
Mouth
Do not lash through block head.
This block only has two laps,
four strands of supplied line.
Rounded
Head
4. Notice: Do not use mouth
as an adjustable block.
Carbo surface will wear or
wear the line if used as a 2:1
adjustable block under load.
2
Laps
2
Sharp
Head
Do not lash through block head.
Advertisement
