IBM 7131-105 User Manual page 90

5.2.3.1 Connecting One 7131 Storage Tower to One System
Use the following procedure to connect one 7131 Storage Tower to one system (see Figure 5-10).
Note: This configuration requires an SE/DIFF card and a terminator.
Figure 5-10. One 7131 Storage Tower Connected to One System
1. DANGER
+--------------------------------------------------------------------+
¦ To prevent a possible electrical shock during an electrical storm, ¦
¦ do not connect or disconnect cables or station protectors for
¦ communications lines, display stations, printers, or telephones.
¦ (RSFTD003)
+--------------------------------------------------------------------+
2. DANGER
+--------------------------------------------------------------------+
¦ To prevent a possible electrical shock from touching two surfaces
¦ with different electrical grounds, use one hand, when possible, to ¦
¦ connect or disconnect signal cables.
+--------------------------------------------------------------------+
3. You can install a total of 7 devices
4. Use device addresses 0 through 6 (see Figure 5-11).
5. Connect the SCSI cable to the back of the 7131 Storage Tower (see Figure 5-11).
7131-105 User's Guide
Connecting One 7131 Storage Tower to One System
(RSFTD004)
¦ Copyright IBM Corp. 1995, 1996
5.2.3.1 - 1
¦
¦
¦
¦
¦