IBM 7131-105 User Manual page 87

5.2.2 Connecting a 7131 Storage Tower with a Single-Ended SCSI
This base configuration consists of one 7131 Storage Tower connected to one system. No SE/DIFF card is required.
Connect a 7131 Storage Tower to 1 system (Figure 5-8).
Figure 5-8. One 7131 Storage Tower Connected to One System (Single-Ended
SCSI)
1. DANGER
+--------------------------------------------------------------------+
¦ To prevent a possible electrical shock during an electrical storm, ¦
¦ do not connect or disconnect cables or station protectors for
¦ communications lines, display stations, printers, or telephones.
¦ (RSFTD003)
+--------------------------------------------------------------------+
2. DANGER
+--------------------------------------------------------------------+
¦ To prevent a possible electrical shock from touching two surfaces
¦ with different electrical grounds, use one hand, when possible, to ¦
¦ connect or disconnect signal cables.
+--------------------------------------------------------------------+
3. You can install a total of 7 devices.
4. Use device addresses 0 through 6.
5. Connect the SCSI cable to the back of the 7131 Storage Tower (see Figure 5-9).
7131-105 User's Guide
Connecting a 7131 Storage Tower with a Single-Ended SCSI
(RSFTD004)
¦ Copyright IBM Corp. 1995, 1996
5.2.2 - 1
¦
¦
¦
¦
¦