Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for NSK ULTIMATE XL
Summary of Contents for NSK ULTIMATE XL
- Page 1 English Micromotor for Laboratory Work OPERATION MANUAL...
-
Page 2: Table Of Contents
Thank you very much for purchasing ULTIMATE XL. Please read this Operation Manual carefully regarding the instructions for use, handling method, and maintenance and inspection prior to use and store it in a place where users can review it anytime. - Page 3 A. GROUNDING INSTRUCTIONS 8. USE PROPER EXTENSION CORD. Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your 1. In the event of a malfunction or breakdown, grounding provides a path of least resistance for product will draw.
-
Page 4: Important Instructions And Warning
Hand/Foot Selector Switch order to avoid damage caused by impact shock. Motor Switch Motor LED C. Important Instructions and Warning on ULTIMATE XL. Indicator Speed Control Knob No lubrication is required to either motor or handpiece because ball bearings impregnated with Speed Limit Release Button grease in both motor and handpiece. -
Page 5: Set Up Of Control Unit
2. Set up of Control Unit 3. Operation Procedure 1. Mounting of Motor Connect Power Cord to a wall outlet. 2. Make sure that Speed Control Knob is at the lowest speed position. Insert the motor cord plug locator into Motor 3. -
Page 6: Speed Limit Mechanism
4. Speed limit mechanism 7. Error Code For the use of a small-diameter round bur or When the motor is stopped due to some trouble such as a failure, overload, wire breakage or misuse, Speed Display displays the error code for checking the status of the unit and fisher bur at 40,000min (rpm) or more, pressing Speed Limit Release Button, which is... -
Page 7: Replacement Of Fuse
If the cause is uncertain, return the product to an authorized light properly, Foot Pedal may be faulty. To cancel this check, press Forward/Reverse NSK's service shop for inspection. Selector Switch again. (5) "in": Initializing function 9. Maintenance Mode... -
Page 8: Handling Of Motor And Handpiece
11. Handling of Motor and Handpiece (3) Insertion of Chuck Turn until finger-tight Turn until finger-tight Turn until finger-tight Thinly apply oil before insertion. Open the ring, (1) Insertion or Removal of Bur insert the dummy bur or the bur in use into The chuck is opened by turning the Bur Lock Ring LOCK the chuck, and turn the chuck clockwise by... -
Page 9: Handpiece Stand
12. Handpiece Stand 15. Troubleshooting At the bottom of the handpiece stand, tools Please check the following points before sending back instruments for repair. necessary for handpiece maintenance and a <Unit / Motor> spare chuck (optional) can be mounted. (Fig. 14) Trouble Cause / Check Remedy... - Page 10 Trouble Cause / Check Remedy Trouble Cause / Check Remedy Make the Vacuum-coupled Mode to The maximum rotation speed for Vacuum-coupled Mode is on, The rotation speed Set the maximum rotation speed with be off. See Vacuum-coupled Mode operation by foot pedal should be while the dust collector is not does not rise.
Need help?
Do you have a question about the ULTIMATE XL and is the answer not in the manual?
Questions and answers