Harken Ti-Lite Carbo AirBlock 351 Instructions

I N S T R U C T I O N S
Ti-Lite Carbo AirBlock
351 (29mm), 2651 (40mm), 2607 (57mm)
1251 E. Wisconsin Avenue • Pewaukee, WI 53072 USA
Tel: 262-691-3320, Fax: 262-691-3008
Web: www.harken.com, Email: harken@harken.com
Strictly follow all instructions to avoid an accident,
damage to your vessel, personal injury or death. See
www.harken.com for additional safety information.
Chart A—Block Specifications
Part Size Maximum Working Load (MWL) Breaking Load (BL)
No. (mm) lb kg
351* 29 330 150
2651* 40 485 220
2607* 57 792 360
*Includes 4' (1.2m) line
Chart B—Line Replacement
Line Ø
Part Reorder
No. Part No.
in mm
351 HCP1438 1/16 2
2651 HCP1419 3/32 2.5
2607 HCP392 1/8 3
Tie Only to Objects with Rounded Edges
WARNING!: Attach only to objects with rounded edges.
Do not tie block to stamped eyestrap. This will cause
line to chafe and break suddenly causing an accident,
damage to your vessel, personal injury or death. See
www.harken.com for additional safety information.
CORRECT INCORRECT
Rounded Sharp
Tie to Mouth of Block
WARNING!: Tie only to the mouth of the block as
shown. Do not tie to head of block. This will cause
the block to break suddenly causing an accident,
damage to your vessel, personal injury or death. See
www.harken.com for additional safety information.
Use Three (3) Loops of Supplied Line
WARNING!: Use three loops of the line supplied.
®
Using fewer loops will weaken the block causing
it to break suddenly causing an accident, damage
to your vessel, personal injury or death. See
www.harken.com for additional safety information.
CORRECT
lb kg
1000 454
1200 544
2380 1080
Line Type
Maxibraid
Maxibraid
Maxibraid
WARNING!: Failure to inspect and replace UV-
damaged, worn or frayed line can cause the line
to break suddenly causing an accident, damage
to your vessel, personal injury or death. See
www.harken.com for additional safety information.
Inspect line for chafe or UV-damage every time you sail. Replace
damaged line immediately. Replace line with no visible damage after
no more than two-years use. Consult Chart B (left) for replacement
line or use block breaking strength, Chart A (left) to select the
correct line.
INCORRECT
3 LOOPS
hEAD
MOUTh
Inspect Line Every Time You Sail
A Tie to Bail/Eyestrap—Parallel
A1 Pass line through
A1
mouth, through head,
around bail, through
head and through
mouth in opposite
direction.
A2 Repeat A1 two times.
A2
See: E Finish—
Dead-End Line.
B Tie to Bail/Eyestrap—Perpendicular
B1 Pass line through
B1
mouth, through head,
around bail so line
crosses. Go through
head and through
mouth in opposite
direction.
B2 Repeat B1 two
B2
times, crossing line
each time.
See: C Tie to Boom.
for complete
instructions.
See: E Finish—
Dead-End Line.