Location And Preparation Of Units - Trane AQUA NEW STYLUS CFEB Series Installation Manual

1. Select an appropriate position that
allows every corner of the room
to be uniformly air conditioned
and where it is easy to route the
water piping.
2. Ensure that the floor or ceiling
construction is sufficient to fully
support the weight of the indoor
unit.
3. Consideration must be given to
ensure an unobstructed flow of
supply and return air.
4. Length of the condensate drain
hose should be kept as short as
possible. (Figure 1)
Figure 1
4
UNT-SVN009-EN.p65

Location and Preparation of Units

5. Recommended service clearance
as shown in figure 2, 3 and 4.
Min.
20 cm.
Maintenance area
(Celling mounted)
Figure 2
Figure 3
4
Min. 120 cm.
Min.
20 cm.
Figure 4
6. Do not install unit in direct sunlight
or near other heat sources as this
may affect performance. Do not
allow outside air to directly enter
unit or condensate may form at
the unit's discharge.
Note: For CFEB 14 - CFEB 20 the
unit should be installed over the
floor at least 20 cm.
UNT-SVN009-EN
9/9/09, 9:56 AM