Advertisement
4. oPeration
4.1.
ensure that you read, understand and apply the safety and operational instructions before proceeding and take care to not touch the
clamps together when the unit is plugged into the vehicle's eobd socket.
4.2.
Before commencing, make sure the 12Volt back-up battery to be used has sufficient charge, at least 12Volts.
ensure that the vehicle's ignition is switched off. locate the vehicle's eobd socket and plug the VS2072.V2 plug into it.
note: If the voltage of the vehicle's battery is low, it is probable that codes will already have been lost, however if there is some
power then the following procedure can still be carried out.
4.3.
Using the back-up 12Volt battery, connect the red clamp to the positive (+) battery terminal and the black clamp to the negative (-)
terminal. The led should now illuminate red. The vehicle's on-board electronics are now powered by the back-up battery and the
vehicle's battery can now be disconnected.
note: If the red led does noT illuminate, check the clamps to the back-up battery and condition of the fuse in the VS2072.V2 fuse
holder, see fig.1. If fuse is blown, replace with identical 5A fuse.
4.4.
Disconnect the vehicle's battery by first removing the clamp from the negative (-) terminal and then from the positive (+) terminal.
4.5.
carry out any work on the vehicle required.
4.6.
Reconnect the vehicle's battery by connecting to the positive (+) terminal first and then to the negative (-) terminal.
4.7.
Disconnect the back-up battery by first disconnecting from the negative (-) terminal and then from the positive (+) terminal.
4.8.
disconnect the VS2072.V2 unit by unplugging it from the vehicle's eobd socket.
4.9.
Store the unit carefully in a safe, dry, childproof location
fig.1
Weee regULations
dispose of this product at the end of its working life in compliance with the eU directive on Waste electrical and electronic equipment
(Weee). When the product is no longer required, it must be disposed of in an environmentally protective way. contact your local solid
waste authority for recycling information.
enVironment Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
sealey group, kempson Way, suffolk business Park, bury st edmunds, suffolk. iP32 7ar
01284 757500
© Jack Sealey limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
VS2072.V2 Issue 2 (F) 08/05/18
Advertisement
