Samsung SGHA827 User Manual page 70

messages or e-mails. Although the active connection can be
changed by the user, it is recommended that this choice be made
with the assistance of either the retailer or customer service
representative.
1. At the Idle screen, select Menu
Settings, and press the
Use the Up or Down Navigation key to highlight one of
2.
these options and press the
• MEdia Net
• AT&T MMS
• AT&T IMS
Important!: The WAP browsers are pre-configured. Your phone is set up by
default for connecting to the network. If you change the settings
without first checking with your service provider, the web
browser, MMS, and e-mail features may not work properly.
To create a new connection, press the Options soft key,
3.
select New, and press the
- or -
To edit the existing MMS, highlight this entry, press the
4.
Options soft key, select Edit, and press the
Select the parameter you want to edit:
5.
67
➔ ➔
MEdia Net Browser
key.
key:
key.
key.
• Set Name: enter a profile name.
• Access Name: edit the access point name.
• Auth Type: select the type of authentication used for this WAP
connection: None, Normal, or Secure.
• User ID: enter the User ID required to connect to the network.
• Password: enter the user password required to connect to the
network.
• Protocol: set the connection protocol used by the WAP browser:
WAP or HTTP.
• Home URL: enter the URL address of the page to be used as your
homepage.
• Proxy address: (HTTP only) set the proxy server address and port.
• Linger Time (Sec.): sets a time period (in seconds) after which the
network is disconnected if there is no new data traffic.
• Advanced Settings: allows you to configure some of the IP-specific
information: Static IP, Static DNS, Server information, and Traffic
Class.
– Static IP: specify if you want to manually enter an IP address. If you
want the IP address to be automatically assigned by the server, remove
the check mark.
– Local Phone IP: enter the IP address obtained from the network
operator, if you checked the Static IP option.
– Static DNS: specify if you want to manually enter the Domain Name
Server (DNS) address. If you want the address to be automatically
assigned by the server, remove the check mark.