Beat Junior User Manual page 6

English
Hi-At assembly instructions
13) For putting together the Hi Hat stand,
begin by folding the three legs on the
bottom half of the stand. There is a thin
metal upper pull rod that you tighten into
the base of the Hi Hat stand. After you've
done this, place the upper tube over the
top of this pull rod and down into the
base of the stand. Simply tighten down
the T-rod located at the top of the base of
the stand to hold the upper tube in place.
14) Remove the bottom stop nut, metal
washer and felt washer from the Hi Hat
clutch and insert the clutch thru the top
Hi Hat cymbal. Place the other felt thru
the bottom of the clutch and make it so
it is in contact with the bottom of the
cymbal. Following that, place the metal
washer provided onto the felt and tighten
the stop nut onto the clutch and against
washer.
15) Place the lower Hi Hat plate on the
upper support / pull rod. Then place the
top plate on top and you're done with Hi
Hat support.