AEG FAVORIT 45020 VI User Manual page 27

7.2 Setting and starting a
programme
Setting mode
The appliance must be in setting mode
to accept some operations.
The appliance is in setting mode when,
after the activation, all the programme
indicators come on.
If the control panel shows other condi-
tions, press and hold function buttons
(B) and (C) at the same time until the ap-
pliance is in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode.
3. Press the button of the programme
you want to set.
• The related programme indicator
stays on.
• All the other programme indicators
go off.
4. Close the appliance door. The pro-
gramme starts.
Starting a programme with
delay start
1. Set the programme.
2. Press the delay button again and
again until the indicator of the num-
ber of hours you want to set comes
on. You can set 3, 6 or 9 hours.
• The delay indicator comes on.
3. Close the appliance door. The count-
down starts. When the countdown is
completed, the programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance
stops. When you close the door, the ap-
pliance continues from the point of inter-
ruption.
Cancelling the delay start
while the countdown operates
Press and hold function buttons (B) and
(C) at the same time until all the pro-
gramme indicators come on.
When you cancel a delay start,
the appliance goes back to set-
ting mode. You have to set the
programme again.
Cancelling the programme
Press and hold function buttons (B) and
(C) at the same time until all the pro-
gramme indicators come on.
Make sure that there is detergent
in the detergent dispenser be-
fore you start a new programme.
At the end of the programme
When the programme is completed, an
intermittent acoustic signal operates and
the end indicator comes on.
1. Press the on/off button to deactivate
the appliance.
2. Close the water tap.
If you do not press the on/off
button, the AUTO OFF device
automatically deactivates the ap-
pliance after some minutes. This
helps to decrease the energy
consumption.
• Let the dishes become cold
before you remove them from
the appliance. Hot dishes can
be easily damaged.
• First remove the items from
the lower basket, then from
the upper basket.
• There can be water on the
sides and on the door of the
appliance. Stainless steel be-
comes cool more quickly than
the dishes.
ENGLISH
27