Table of Contents
Advertisement
Wired Remote Controller-Buttons and Display
The wired remote controller is an optional accessory and it is installed on the wall.
To use the wired remote controller, refer to an appropriate manual.
Communication error indicator
On Timer setting
Off Timer setting
Test indicator
Temperature adjustment
On Timer button
Timer Set/Cancel button
Note
8
E-
Removing frost indicator
(Except Cooling Only Models)
buttons
Test button
◆ The
button is for your installation specialist. You must NOT press it.
◆ After cleaning the air filter, press the
controller will display the FILTER SIGN indicator when the time to clean the
air filter; refer to page 12.
◆ Duct type air conditioner does not have function of adjusting air flow direction.
Therefore, the function is not operated even if you press the
Operating mode
Centralized controller indicator
(In case of installing the Centralized controller)
Mode selection button
button. Then the wired remote
Temperature setting
Fan speed
Air flow direction
Filter Sign indicator
On/Off button
On/Off indicator
Fan speed adjustment
button
Swing button
(Not operated)
Filter Reset button
button.
Advertisement
Table of Contents
