Inserting Batteries In The Remote Control; Setting The Time - Medion MD 19500 User Manual

Charging using the charging station
 Connect the mains cable to the mains connection on the charging station. The
operating lights on the charging station light up green. Place the robot vacuum
cleaner onto the charging station so that the charging contacts lie on top of
each other.
 Make sure the contacts are clean.
 Insert the mains plug into the mains socket.
The appliance is charged, all operating LEDs on the robot vacuum cleaner flash.
Once the battery block is fully charged, all six LEDs light up permanently.
The lower and middle LED operating lights on the robot vacuum cleaner flash if the
battery block is half charged.
At the latest, the battery block must be charged when the lower LED operating
lights on the robot vacuum cleaner flash.
 Charge the battery block before the next cleaning operation either using the
mains adapter on the appliance or, when the charging station is connected, the
robot vacuum cleaner returns automatically for charging when the battery level
is low. This return to the charging station interrupts the cleaning process.
If battery performance is drastically reduced, contact the Medion
Service Centre.

6.4. Inserting batteries in the remote control

 Push the battery compartment cover on the back of the remote control
downwards.
 Insert two 1.5 V batteries of type AAA/LR03 and observe the polarity shown in
the battery compartment.
 Replace the battery compartment cover on the battery compartment again and
push it closed.

6.5. Setting the time

In order to use the start time function, the time must have been set on the remote
control in advance. Proceed as follows:
 Press the
button to set the current time.
IT
EN
SI
HR
55