PROEL PLML150E User Manual page 20

Adjustment nt nt nt Adjustme
Adjustme Adjustme
DISPLAY DESCRIPTION
ADJUST Press and rotate the knob to select the motor of which to
calibrate the position.
PAN, TILT, COLOR, GOBO are respectivelly the motors of
PAN, TILT, Colour Wheel and Gobo wheel. Once you have
selected the value, press the rotating knob to fix the value,
then select Exit to confirm and exit.
Restoring the default setting Restoring the default setting Restoring the default setting Restoring the default setting
DISPLAY DESCRIPTION
DEFAULT Press and rotate the knob to select Default from the menu.
Select yes to restore the original setting.
Reset Reset
Reset Reset
DISPLAY DESCRIPTION
RESET Press and rotate the knob to select Reset from the menu.
Select yes to enable the reset.
After switching on, the moving head will automatically detect whether
DMX 512 data is received or not. No data receiving can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not
connected with the input of the moving head.
- the controller is switched off or defective, if the cable or connector is
defective or the signal wires are swap in the input connector.
- noise occurrence in the signal cable. Try to insert the XLR termination
plug (with 120 Ohm) in the last lighting in the link in order to ensure
proper transmission on the DMX data link.
20