Table of Contents
Advertisement
I
A
NSTALLING THE
IR CONDITIONER
Connecting the Assembly Cable
Indoor Unit
1
2
N 1
2
E
1
N1
1
N
E
2
1
N1
Outdoor Unit
N 1
1
2
**Screws on terminal block must
not be unscrewed with the torque
less than 12 kgf . cm.
The designs and shape are subject to change
according to the model.
8
E-
The outdoor unit is powered from the indoor unit through the assembly cable.
If the outdoor unit is more than 5 meters away from the indoor unit, you must
extend the cable. The maximum length of the cable is 15 meters.
1
2
3
3
4
3
5
3
6
3
7
8
9
10
Power cable specification
**07**
**09**
Extend the assembly cable if necessary.
Remove the cover terminal on the side of the indoor unit.
Pass the assembly cable through the rear of the indoor unit and connect
the assembly cable to terminals as seen in the picture.
Each wire is labeled with the corresponding terminal number.
Pass the other end of the cable through the 65mm hole in the wall.
Close the connector cover tightening the screw carefully.
Close the cover terminal.
Remove the terminal board cover on the side of the outdoor unit.
Connect the cables to the terminals as seen in the picture.
Each wire is labeled with the corresponding terminal number.
Connect the earth conductor to the earth terminals.
Close the terminal board cover tightening the screw carefully.
Specially for Russian and European market, Before installation,
the supply authorithy should be consulted to determine the
supply system impedance to ensure compliance.
Model
Power cable
-
-
Connect the power cable to the auxiliary circuit breaker
If every pole fails to connect to the power supply, it must
be incorporated in a wire with a contact opening of >3mm.
.
Interconnection cable
2
5G, 0.75mm
H05VV-F
2
5G, 1.0mm
H05VV-F
Advertisement
Table of Contents
