■
Do not exert excessive pressure and only
along the length of the drill bit (no lateral
pressure). Drill bits can bend and break which
can lead to a loss of control and injuries.
Original accessories/auxiliary
equipment
■
Use only the accessories and additional equip-
ment that are specified in the operating instruc-
tions and are compatible with the appliance.
Safety guidelines for battery
chargers
This appliance may be used by chil-
■
dren aged 8 years and above and
by persons with limited physical,
sensory or mental capabilities or
lack of experience and knowledge,
provided that they are under super-
vision or have been told how to use
the appliance safely and are aware
of the potential risks. Do not allow
children to use the appliance as a
toy. Cleaning and user maintenance
tasks may not be carried out by
children unless they are supervised.
The charger is suitable for
indoor use only.
WARNING!
■
To avoid potential risks, damaged mains cables
should be replaced by the manufacturer, their
customer service department or a similarly
qualified person.
ATTENTION!
►
This charger can only charge the following
batteries: PAPK 12 A1 / PAPK 12 A2,
PAPK 12 B1.
►
A current list of battery compatibility can
be found at www.lidl.de/akku.
│
GB │ IE
■
20
Before use
Removing/charging/inserting the
battery pack
NOTE
►
The battery is partially charged. Ideally, fully
charge the battery before use. You can
charge the lithium-ion battery at any time
without shortening its service life. Interrupting
the charging process does not damage the
battery.
►
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should
be checked regularly. The optimum charge
level is between 50% and 80%. The storage
climate should be cool and dry and the
ambient temperature should be between
0°C and 50°C.
CAUTION!
►
Always unplug the appliance before you
remove the battery pack
the battery pack to the charger.
1.) To remove the battery pack
release button
and pull the battery pack
out of the appliance.
2.) Insert the battery pack
charger
.
3.) Insert the power plug into the socket. The red
charge indicator LED
4.) The green charge indicator LED
that the charging process is complete and the
battery pack
is ready for use.
5.) Push the battery pack
ance.
Checking the battery charge level
When the appliance is switched on, the remaining
charge will be shown on the battery LED
follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
from or connect
, press the
into the battery
lights up.
indicates
back into the appli-
as
PBSA 12 D3