Operation; Charging The Battery Pack - Toro Power Plex 88540 Operator's Manual

Operation

Charging the Battery Pack

Important: The battery pack is not fully charged when
you purchase it. Before using the tool for the first time,
place the battery pack in the charger and charge it
until the LED display indicates the battery pack is fully
charged. Read all safety precautions.
Important: For best results, charge your battery pack
in a location where the temperature is more than 0°C
(32°F) but less than 50°C (122°F). To reduce the risk of
serious personal injury, do not store the battery pack
outside or in vehicles. Charging time increases if you do
not charged it within this range.
Note: At any time, press the battery-charge-indicator button
on the battery pack to display the current charge (LED
indicators).
1. Make sure that the vents on the battery are clear of any
dust and debris.
2. Line up the cavity in the battery pack
the tongue on the charger.
Model 88540
1. Battery pack cavity
2. Battery pack terminals
3. Battery pack venting areas
(Figure
Figure 2
4. Battery-charge-indicator
button
5. LED indicators (current
charge)
1. Battery pack cavity
2. Battery pack terminals
3. Battery pack venting areas 7. Flashlight
2) with
4. Battery-charge-indicator
button
Note: Quickly press the battery-charge-indicator
button twice to turn the flashlight on or off (battery
pack Model 88541 only). The flashlight automatically
shuts off after approximately 60 minutes of use.
Note: The USB port is provided for your convenience
to charge small electronics such as your cell phone or
tablet (battery pack Model 88541 only).
3. Make sure that the vents on the battery charger are
clear of any dust and debris.
4. Slide the battery pack into the charger until it is fully
seated
g192748
7
Figure 3
Model 88541
5. LED indicators (current
charge)
6. Handle
8. USB port (not shown;
located under handle)
(Figure 4).
g192773