UTC Fire and Security Det-Tronics R8471B Instructions Manual page 15

CONTROLLER
POSITIONS FOR:
FIRE
8
6
4
3
2
1
(E)
B1475
THE Q4004 CONTROLLER CAGE HAS BEEN MODIFIED
TO ACCOMMODATE EITHER FIRE OR GAS CONTROLLERS
BY FOLLOWING THE INSTRUCTIONS BELOW, THE CAGE
1
SET
A1476
2.1
HT: DIM. (A)
GAS INCH MM
16 4U 19.00 482.6
12 4U 15.06 382.6
8 4U 11.13 282.6
6 4U 9.16 232.7
4 4U 7.19 182.7
2 4U 5.22 132.6
16 3U 19.00 482.6
12 3U 15.06 382.6
8 3U 11.13 282.6
6 3U 9.16 232.7
4 3U 7.19 182.7
2 3U 5.22 132.6
(A)
(B)
(C)
Figure 9—Dimensions of the Q4003 and Q4004 Mounting Racks
OR ANY COMBINATION OF THE TWO.
CAN BE SET UP TO ANY CONFIGURATION.
2 3
GAP SET
Figure 10—Clip Positioning for Q4003 and Q4004 Mounting Racks
DIM. (B) DIM. (C)
INCH MM INCH MM
18.30 464.8 17.36 440.9
14.36 364.7 13.42 340.9
10.43 264.9 9.49 241.1
8.46 214.9 7.52 191.0
6.49 164.9 5.55 141.0
4.52 114.8 3.58 90.9
18.30 464.8 17.36 440.9
14.36 364.7 13.42 340.9
10.43 264.9 9.49 241.1
8.46 214.9 7.52 191.0
6.49 164.9 5.55 141.0
4.52 114.8 3.58 90.9
2
13
DIM. (D) DIM. (E)
INCH MM INCH MM
4.00 101.6 6.97 177.1
2.25 57.15 5.22 132.6
1.48 (37.59)
(D)
ALL CONTROLLER CAGES REQUIRE
A MINIMUM OF 10.12 INCHES (257.1 MM)
DEPTH CLEARANCE
FIRE CONTROLLERS ARE APPROX. TWO INCHES
WIDE AND REQUIRE TWO GUIDE RAILS FOR
1
INSERTION. PLACE THE RETAINING CLIP BETWEEN
RAILS TO FORM SETS, LEAVE A GAP BETWEEN SETS.
TO INSERT A BLANK PANEL, PLACE A CLIP IN
THE TOP BRACKET IN LINE WITH THE CLIP IN THE
2
BOTTOM BRACKET.
GAS CONTROLLERS ARE APPROX. ONE INCH WIDE
AND REQUIRE ONE RAIL FOR INSERTION. PLACE CLIPS
3
IN LINE WITH GUIDE RAILS, CAGES WILL ACCEPT AS
MANY GAS CONTROLLERS AS RAILS PROVIDED.
95-8401