Advertisement
Tips for Best Performance
• For best results, use a Dry Sweeping Pad or vacuum to pick up dirt and dust before
running your robot with a Wet Mopping or Damp Sweeping Pad.
• Do not presoak cleaning pads before attaching them to the robot. Pads should be
dry at the start of a cleaning cycle.
• To pause your robot during a cleaning cycle, press the CLEAN button. To resume the
cleaning cycle, press the CLEAN button again. Do not pick up and move your robot
while it is cleaning – the robot will end its cleaning run if you do.
• To turn off your Braava jet, press and hold the CLEAN button for 5 seconds.
• Tilt robot slightly when filling to ensure tank fills completely.
• Your robot will only run with Braava jet pads, which are specifically made for the robot.
• Braava jet cleans best on smooth hard surfaces and may not perform as well on
uneven tiles, heavily waxed floors, or rough surfaces like slate or brick which may snag
the cleaning pads.
• Lift up floor-length curtains before running Braava jet.
Advertisement
