Table of Contents
Advertisement
Setting an indoor unit address and installation option
Setting an indoor unit installation option
1.
Check whether power is supplied or not.
- When the indoor unit is not plugged in, there should be additional
power supply in the indoor unit.
2.
The panel(display) should be connected to an indoor unit to receive
option.
3.
Set the installation option according to the installation condition of an air
conditioner.
- The default setting of an indoor unit installation option is
"020010-100000- 200000-300000".
- Individual control of a remote controller(SEG20) is the function that controls an
indoor unit individually when there is more than one indoor unit.
4.
Set the indoor unit option by wireless remote controller.
02 series installation option
SEG1
SEG2
0
2
SEG7
SEG8
1
Drain pump
SEG13
SEG14
2
External control
SEG19
SEG20
3
-
1 WAY / 2WAY / 4WAY, DUCT MODEL : Number of hours using filter(SEG18) will be set to '1000 hour' even if the SEG18 is
When setting the option other than above SEG values, the option will be set as "0".
SEG5 central control option is basically set as 1 (Use), so you don't need to set the central control option additionally.
However, if the central control is not connected but it doesn't indicate an error message, you need to set the central
control option as 0 (Disuse) to exclude the indoor unit from the central control.
SEG3
-
SEG9
-
SEG15
External control output
SEG21
Heating setting
compensation
set to exept for 2 or 6.
ENGLISH-32
SEG4
-
SEG10
-
SEG16
-
SEG22
EEV Step of
stopped unit during
oil return/defrost
mode
Indoor Unit
SEG5
Central control
SEG11
SEG12
EEV Step when
Master / Slave
heating stops
SEG17
SEG18
Number of hours
-
using filter
SEG23
SEG24
-
SEG6
-
-
Advertisement
Table of Contents
