To Disassemble The Brass Connector Inside The Outlet; To Disassemble/Assemble The Start/Stop Valve - Husqvarna PW 450 Workshop Manual

Repair instructions
2.5 To disassemble the brass
connector inside the outlet
1. Remove the brass connector. Use an M8 puller, part
number 592 94 49-01.
2. Remove the injector. Use an M6 puller, part number
592 94 48-01
2.6 To disassemble/assemble the
start/stop valve
1. Remove the U-pin.
2. Remove the start/stop valve.
3. Remove the ball seat. Use an M8 puller, part number
592 94 49-01
NOTE: This can be done without removing the motor/
pump unit from the cabinet.
English – 13