Table of Contents
Advertisement
Note: Schematic depicted is an example only. It is the responsibility of the installer to
design and install a suitable circulation system based on each installation's unique
conditions.
Installation Checklist
Minimum clearances to combustibles checked
Minimum clearance for removal of Coal Feed Screw checked
Floor protector fitted (if required)
Appliance securely fastened to support
Water system sealed, pressurised, properly bled and leak tested
Flue installed to AS/NZS 2918:2001 and/or any other local regulations
Pressure relief valve installed and piped safely
Water pump wired into appliance
Appliance plugged into suitable wall electrical socket (NOT hard wired)
Controller mounted on wall in accessible position
Water temperature set at 75°C minimum (dependent on system design)
Appliance run up to temperature at least once
Customer shown basic operation of appliance
Warranty card filled out
F:\C - E\ECOMAX\COAL BOILER\Instructions and Manuals\Coal Boiler Manual Rev 6.doc
Page 19 of 36
Advertisement
Table of Contents
