Advertisement
5
Install the server onto the slide rail assembly
Before installing the server onto the slide rail assembly, ensure that the
leveling feet are extended and that the stabilizer bracket is correctly installed
to prevent the rack from falling forward.
Before you begin: Read this entire task before completing any individual steps.
Attach the four blue knobs
5.1
to rest the server on the slide rails for installation. These knobs will be removed after
the server is secured to the slide rails.
5.2
Fully extend both slide rails.
Use safe practices when lifting.
Lift the server using the handles
5.3
extended slide rails. Align the three holes of the inner slide rails
on each side of the server.
Using a screwdriver, attach the inner slide
5.4
of the slide rails
server by using the system-to-slide-rail
screws . Use a screwdriver to tighten
each of the screws.
5.5
Remove the four blue knobs .
Simultaneously release the blue safety
5.6
latches
slide rail assembly, and slowly push the
server back into the rack.
Tip: Pull the server back out and push it in again to make sure that the slide
rails are aligned correctly and that it glides smoothly.
Using a screwdriver, tighten the two rack-retaining screws to secure the slide rails to
5.7
the back of the rack.
Slide the server part of the way out of the rack. Using a screwdriver, tighten the front
5.8
two rack-retaining screws and the two latch-bracket screws on the front of the rack to
secure the slide rails.
B
D
to each side of the
E
F
located near the front of each
A.
to the server
The blue knobs are used temporarily
32-55 kg (70.5-121.2 lbs)
C
,
on each side and position the server on the
A
B
F
D
with the three holes
B
C
Actual size
part 04N6485
D
E
Advertisement
