Advertisement
3. Align the retracted back pins
placement dot. Place the rack flange
retracted alignment pins .
4.
Press the back latch-assembly-release tab
the back of the rack.
From the back, finger-tighten one of the rack-retaining screws
4.5
is located between the two back alignment pins .
From the front, finger-tighten one of the rack-retaining screws
4.6
above the front alignment pin .
From the front, attach the system-unit-
4.7
latch bracket
into the rack hole above the hole
where you will place the latch bracket
screw. Finger-tighten the screw.
Repeat steps 4.4 through 4.7 for
4.8
each slide rail assembly.
Actual size
part 26H7213
E
with the holes as identified by the self-adhesive
E
C
E
G
F
J
K
by inserting the hook
L
Actual size
part 12J5289
F
between the slide-rail flange
C
to extend the back alignment pins into
Actual size
part 12J5289
H
E
K
L
I
G
and the
H
in the hole that
I
in the first hole
J
Advertisement
