Operation - Busch-Jaeger Transcontrol HF 6860 Manual

Operation

CAUTION
If blind mode is required, the motor should be disconnected from the switch
output terminal during the programming phase in oder to prevent damage
during programming/selection of the mode of operation. To do this, simply
remove the plug from the supply terminal of HF Receiver 6866 AG (see Fig. 1, Pos. 1).
• Attach the plug again only after the mode of operation has been selected
(coding switch position 8 or 9).
Upon actuation of the coding switch, all channels are switched off (pushbutton
function, blind mode, no function) until operation again via the manual transmitter
or the Transmitter Module.
a. To program
To allocate one of the 6 possible send addresses to a channel of HF Receiver 6866 AG:
• Remove the housing from the device.
• Via the coding switch (see Fig. 1, Pos. 5), select the channel to which the
address is to be allocated (coding switch position 1 to 3).
• Activate the Transmitter Module or press the desired button on the HF Manual
Transmitter (the button "ALL OFF" can be used for programming):
- for the purpose of control, the LED (see Fig. 1, Pos. 4) illuminates for the
length of time a signal is received
- the relay of the respective channel switches on briefly twice if programming
was successful.
• If required, allocate further Transmitter Modules/Manual Transmitters to this
channel (max. 6) or
• select another channel to which you want to allocate a send address or on
which you want to set the desired mode of operation (switch, pushbutton,
blind) via the coding switch (coding switch position 4 to 9).
GB