After setting the OIS switch, select the OIS function in
the menu option
1
In Shooting mode, press [MENU].
2
Select Shooting3 (
an option.
OIS
OIS
36
Using the OIS in the menu option
/
3
3
The OIS function is applied only when
Mode 1
pressing the shutter in full or half.
The OIS function is always applied.
Mode 2
) → OIS →
•
The OIS function may not work well in the following
situations:
-
When you take a picture while tracing a moving
object
-
When a big vibration occurs beyond the range of
stabilization
-
When the shutter speed is too slow due to a
circumstance like night shooting
-
When the battery capacity is not sufficient
-
When you are shooting a close-up shot
•
When you use a tripod, please disable the OIS
function since the image can be shaken due to the
vibration of OIS function.
•
If the camera is struck or dropped while you are
taking a picture, the display can be impaired. If this
occurs, turn the camera off and then on, and the
camera should operate normally again.
•
Since the battery consumption can increase along
with the use of OIS function, it is recommended to
use the function only if needed.
•
To set the OIS function by using the menu, set
[OIS] of lens to ON. This function may not operate
depending on the lens model.
•
The function can be set directly by pressing [Fn] in
the shooting mode.