Setting Up; Inflation; Paddle Assembly; Footrest Cushion Assembly - Mistral VENTURA Instructions For Use Manual

KEEP THESE INSTRUCTIONS FOR USE IN
THE FUTURE
˜ Setting up
1 . Unroll the kayak on an even, level surface
without any kind of debris .
2 . Assemble the removable fins to the bottom of
the kayak. Make sure the outward curvature
of the fin is pointing towards the back end of
the kayak.
NOTE: Assemble the fin before inflation and also
disassemble it after deflation.
NOTE: To avoid damage to the removable fin,
do not enter shallow water with it.
˜ Inflation
NEVER USE COMPRESSED AIR FROM A
COMPRESSOR TO INFLATE INFLATABLES
WITH AIR. THIS CAN DAMAGE YOUR
PRODUCT AND VOID YOUR WARRANTY
Inflate the air chambers with the hand air pump
supplied with the product or any other suitable
hand pump.
18 GB/IE
Caution: Under and over-inflation of the kayak
will result in safety hazards. It is better to check
the pressure of the kayak each time before use.
NOTE: Pressure gauge is intended for inflation
only. The value shown on the pressure gauge is
just for reference. It should not be used to act as a
precision instrument.
Never stand on or rest objects on the kayak
during inflation.
Inflate the bottom chamber until they are stiff
to the touch but NOT hard to feel.
NOTE: All drawings are for illustration
only. They may not reflect actual
product accurately.
˜ Paddle assembly
Safety rope installation
Insert the rope into the holes of the D-buckles (1).
Then tie the ends of the rope to the D-buckles (1).
Caution:
1. Safety ropes shall be fitted to both sides of
the bow and stern areas only and shall not
impede the normal operation of the kayak.
2. Do check carefully if a safety rope is
tightened well.
˜ Footrest Cushion Assembly

INFLATION

1. Open valve and inflate footrest cushion with
the air pump with matching adaptor.
2. Fill the cushion until most of the wrinkles are
gone and it feels firm to touch but NOT hard.
Note: Do not over-inflate the cushion. Do
not use an air compressor. Under and
overinflation of the cushion will result in safety
hazards.
3. Be sure to close the valves after inflation,
press in the safety valves after inflation.
4. Place the footrest cushion at the most front
position the kayak.