Hover-1 DREAM Operation Manual page 19

• While sustaining a high discharge current during use (such as
driving up a steep slope for a long period of time), the Dream
engine will power off and stop after 15 seconds.
CHARGING YOUR DREAM
CHARGING THE DREAM
• Ensure that the charging port is clean and dry.
• Make sure that there is no dust, debris or dirt inside the port.
• Plug the charger into a grounded wall outlet. The charging
indicator light ON THE CHARGER will be green.
• Connect the cable with the power supply (100V ~ 240V; 50/60 Hz).
• Align and connect the 4-pin charging cable into the charging
port of the Dream. DO NOT FORCE THE CHARGER INTO THE CHARGE
PORT, AS THIS MAY CAUSE THE PRONGS TO BREAK OFF OR
PERMANENT DAMAGE TO THE CHARGE PORT.
• Once attached to the board, the charging indicator light ON THE
CHARGER should change to RED, indicating that your device is now
being charged.
• When the RED indicator light on your charger turns to GREEN, then
your Dream is fully charged.
• A full charge may take up to 5 hours. While charging, you will see
a yellow flashing light on the scooter, which also indicates charging.
Do not charge for more than 7.5 hours.
•After fully charging your Dream, unplug the charger from your
Dream and from the power outlet.
WARNING
When the Dream turns off during a
Safety Alert, all operation systems will
halt. Do not continue attempting to ride
the Dream when the system initiates a
stop. Turn your Dream off and back on
to unlock it from a Safety Lock.
17