Advertisement
PM5-SA4
6.2
Insert the PM5-SA4 plug-in module
1.
Use plug-in connector 1 (on the left) for the installation of the
PM5-SA4 plug-in module.
2.
Dismantle the cable (or cables) on the required length inside the
casing and insert it (them) into the casing through one or more
cable glands.
IMPORTANT NOTICE!
In order to minimize the influence of possible inductive
disturbances, we recommend to use cables with
twisted cable pairs for each channel..
3.
Now connect the cable ends to the connection terminals of the
PM5-SA4 plug-in module. The digits 1 to 4 indicate the channel
numbers which you can later select in the configuration menu.
6
4.
Insert the PM5-SA4 plug-in module carefully into the plug-in
connector 1 (on the left).
HAZARD!
Improper positioning
Improper (inaccurate) positioning of the plug-in module
and applying too strong forces may bent or even break
the contact pins of the plug-in connector.
Potential consequence: Irreparable damage of the
plug-in connector, need for factory repair service.
Take care for the correct and accurate position of the
plug-in module and do not apply too strong forces.
Advertisement
