Basic Setup; Altitude Adjustment; Setting The Date And Time; Changing The Display Language - Samsung SCX-5835NX User Manual

basic setup

10.
After installation is complete, you may want to set the machine's default settings. Refer to the next section if you would like
to set or change values. This chapter gives you step-by-step instructions for setting up the machine.
This chapter includes:
•

Altitude adjustment

•

Setting the authentication password

•

Setting the date and time

•

Changing the display language

• Changing the country
• Setting job timeout
ALTITUDE ADJUSTMENT
The print quality is affected by atmospheric pressure, which is determined
by the height of the machine above sea level. The following information will
guide you on how to set your machine to the best print quality or best quality
of print.
Before you set the altitude value, find the altitude where you are using the
machine.
0
1. Turn your networked computer on and open the web browser.
2. Enter your machine's IP address as the URL in a browser.
3. Click Go to access the SyncThru™ Web Service.
4. Click Machine Settings.
5. Click Altitude Adj.
6. Select the appropriate altitude value.
7. Click Apply.
If your machine is connected via a USB cable, set the altitude in
Altitude Adjustment option on the machine's display screen. (See
"General settings" on page 85.)
SETTING THE AUTHENTICATION PASSWORD
To set up your machine or change the settings, you must first login. To
change password, follow the steps below:
1. Press Machine Setup on the control panel.
2. Press Admin Setting.
•
•
•
•
•
3. When the login message appears, enter password with the number
4. Press the Setup tab > Authentication.
5. Press Change Admin. Password.
6. Enter old and new password, and then confirm the new password.
7. Press OK.
SETTING THE DATE AND TIME
When you set the time and date, they are used in delay fax and delay print.
They are printed on reports. If, however, they are not correct, you need to
change it for the correct time being.
1. Press Machine Setup on the control panel.
2. Press Admin Setting.
1 Normal
3. When the login message appears, enter password with number keypad
2 High 1
4. Press the General tab > Date & Time > Date & Time.
5. Select date and time using left/right arrows. Or touch the insert area and
6. Press OK.
CHANGING THE DISPLAY LANGUAGE
To change the language that appears on the display, follow the steps below:
1. Press Machine Setup on the control panel.
2. Press Admin Setting.
3. When the login message appears, enter password with number keypad
4. Press the General tab.
5. Press the down arrow to switch the screen and press Language.
6. Select the appropriate language.
7. Press OK.
Basic setup_ 33
Using power saving feature
Setting the default tray and paper
Changing the default settings
Changing the font setting
Understanding the keyboard
keypad on the control panel to enter the password. Then, press OK.
(Factory setting:1111)
If the machine's power is cut off, you need to reset the correct time
and date once the power has been restored.
and press OK. (See "Setting the authentication password" on page 33.)
use the numeric keypad on the control panel.
To change the format of date and time, press Date Format and Time
Format.
and press OK. (See "Setting the authentication password" on page 33.)