Advertisement
8.
Press again the << MODE >> button shortly (less than 2 seconds) to get to the alarm temperature
activation screen. Upper line indicating "Alarm", lower line indicating "on" or "off". Here you can set if an
alarm should be output when a temperature limit has been exceeded or not.
Press << 0 >> to toggle between "on" and "off".
9.
Press again the << MODE >> button shortly (less than 2 seconds) to get to the initial main screen (Fig. 4-
5). Now you are ready to start the operation by simply pressing the button << 5 >>. The ● symbol will light
up in the upper left corner to show that operation is in progress.
You may stop the redundancy operation at any time by simply pressing button << 5 >> in this screen
again. The ● symbol will go off then.
Fig. 4-4
Fig. 4-5
14
Advertisement
