Samsung SyncMaster 913B User Manual page 78

Before calling for service, check the information in this section to see if you can remedy any
problems yourself. If you do need assistance, please call
Information section or contact your
Symptom
No images on the
screen. I cannot turn
on the monitor.
dealer.
Check List
Is the power cord
connected properly?
Can you see "Check
Signal Cable" on the
screen?
If the power is on, reboot
the computer to see the
initial screen(the login
screen), which can be
seen.
Can you see "Not
Optimum
Mode","Recommanded
Mode 1280 x 1024 60Hz"
on the screen?
SyncMaster 913N / 915N
the phone number on the
Solutions
Check the power cord connection
and supply.
Check the signal cable connection.
If the initial screen (the login screen)
appears, boot the computer in the
applicable mode (the safe mode for
Windows ME/XP/2000) and then
change the frequency of the video
card.
(Refer to the Preset Timing
Note: If the initial screen (the login
screen) does not appear,
the Service Center or your
You can see this message when the
signal from the video card exceeds
the maximum resolution and
frequency that the monitor can
handle properly.
Adjust the maximum resolution and
frequency that the monitor can
handle properly.
If the display exceeds SXGA or
75Hz, a "Not Optimum
Mode","Recommanded Mode
1280 x 1024 60Hz" message is
displayed. If the display exceeds
85Hz, the display will work properly
but the "Not Optimum
Mode","Recommanded Mode
1280 x 1024 60Hz" message
appears for one minute and then
disappears.
Please change to the recommended
Modes)
contact
dealer.