Page 1
Enigma a a nd M M irror G G lass ELECTRIC W W ALL M M OUNTED H H EATERS MODELS P P 23E INSTALLATION A A ND USER I I NSTRUCTIONS Read a a nd u u nderstand t t hese i i nstructions c c ompletely b b efore c c ommencing a a ny a a ssembly o o r i i nstallation.
Servicing PRELIMINARY N N OTES The Enigma and Mirror Electric Wall Heaters provide convected heating in conjunction with a visual fuel effect display. The appliance is designed for indoor use, and can be flat wall mounted in the majority of wall positions antici- pated.
SITE R R EQUIREMENTS The appliance can be flat wall mounted via the brackets on the rear panel with the fixings provided. The wall should be relatively flat and not interfere with any of the ventilation slots in the rear panel. The wall must be structurally sound and of a material capable of withstanding moderate heat.
UNPACKING T T HE A A PPLIANCE Caution: T T his a a ppliance i i s h h eavy. A A lways s s eek a a ssistance w w hilst u u npacking a a nd/or d d uring i i nstallation. Read all the instructions before continuing to unpack or install this appliance.
FIXING T T HE A A PPLIANCE Having selected the final mounting position for the appliance, taking WARNING into account the site requirements as detailed in sections 1.0 - 5.0, the heater can now be fixed to the wall. THE W W ALL W W HERE T T HE A A PPLIANCE I I S T T O BE I I NSTALLED M M UST B B E C C APABLE O O F LONG-T T ERM S S UPPORT O O F T T HE T T OTAL Remove any protective film coatings from the finished/decorative sur-...
Page 7
FIXING T T HE A A PPLIANCE ( ( continued) the screws protruding approximately 6mm from the wall. The appliance can now be “hung” onto the two upper wall fixings, ensuring that the heads of the screws go through the keyhole shaped holes, and then drop down into the keyhole upper slot. Ensure that the lower rear panel fixing hole aligns with the wall plug, and then insert 1 x 37mm long fixing screw and fully tighten.
FIXING T T HE A A PPLIANCE ( ( continued) f) F F itting t t he D D ecorative C C orner C C olumns - E E nigma F F acia o o nly: Front clamping disc To fit the decorative corner columns, ensure the main glass facia is mounted in position.
SAFETY C C UT-O O UT S S YSTEM ( ( continued) 2. Leave the fire OFF for a period of not less than 10 minutes, ensuring any obstructions are removed. 3. Plug in the power supply cable at t t he o o utlet s s ocket, a a nd t t hen s s witch o o n a a t t t he a a ppliance. If the appliance fails to operate correctly, repeat the above procedure.
14.0 SERVICING There a a re n n o i i nternal u u ser s s erviceable p p arts. Check regularly for security of wall fixings and front facia as appropriate. Also check the security and condition of the supply cable and connections. If the supply cable becomes damaged, it must be replaced by a service agent or competent person, such as a qualified electrician.
Need help?
Do you have a question about the Enigma and is the answer not in the manual?
Questions and answers