Page 1
MONET a a nd T T RINITY ELECTRIC W W ALL H H EATERS MODEL : : P P 23E INSTALLATION A A ND U U SER I I NSTRUCTIONS All i i nstructions m m ust b b e h h anded t t o u u ser f f or s s afekeeping Revision B - 06/06 Country(s) of destination - GB/IE Focal Point Fires plc, Christchurch, Dorset BH23 2BT...
Page 2
MONET ( ( P23E) TRINITY ( ( P23E) Fig 1 Dimensions Monet shown...
Page 3
CONTENTS Section Contents Page No. Section Contents Page No. Preliminary Notes Preparing the Appliance Appliance Data/Specifications Fixing the Appliance Electrical Installation Requirements 10.0 Operating the Appliance Site Requirements 11.0 Safety Cut-Out System Clearances to Combustible Materials 12.0 Maintenance - Lamp Replacement Unpacking the Appliance 13.0 Cleaning...
Page 4
SITE R R EQUIREMENTS The appliances are designed to be wall mounted via the brackets on the rear panel with the fixings provided. The wall should be relatively flat and not interfere with any of the ventilation slots in the rear panel.
Page 5
UNPACKING T T HE A A PPLIANCE Caution: T T his a a ppliance i i s h h eavy. A A lways s s eek a a ssistance w w hilst u u npacking a a nd/or d d uring i i nstallation. Read all the instructions before continuing to unpack or install this appliance.
Page 6
Using the template in the required position on the wall, “mark through” the template and onto the wall at the three mounting locations designated “P23E” for this particular appliance. Now remove the template. B) W W all F F ixings: If the appliance is to be mounted on the inner leaf of a conventional cavity wall or a solid wall, drill three holes using a 7mm masonry bit.
Page 7
10.0 OPERATING T T HE A A PPLIANCE Read A A ll I I nstructions B B efore U U se Check that the heater outlet grille, mounted at the top of the appliance, is not covered or obstructed in any way, and ensure the power to the fire is switched on.
Page 8
12.0 MAINTENANCE ALWAYS D D ISCONNECT T T HE A A PPLIANCE A A T T T HE S S UPPLY O O UTLET SOCKET B B EFORE U U NDERTAKING A A NY MAINTENANCE. Excluding the lamp and fuse, use only genuine spare parts available from your supplier. Replacement lamps must be of the same wattage and specification as those stated in Section 2.0 Appliance Data/Specifications.
Need help?
Do you have a question about the P23E and is the answer not in the manual?
Questions and answers